Samruddhi Industries (Accuplus)

The Bresle Patches will allow you to extract salts from blast-cleaned steel for measurement using the Horiba Conductivity Meter in the Bresle Patch Test.

Salts are almost colourless and are localized at the lowest point of the rust pits.  If they are not removed prior to painting, chemical reactions can result in blister formation and accumulations of rust that destroy the adhesion between the substrate and the applied protective coating.

Supplied in packs of 35.

Compliant to ISO 8502-6.

Latex-free and contamination-free Patches.

The Bresle Patch has a test area of 1250m2 and is suitable for use with 2.5ml of water.

 

The only degeneration on the Bresle Patches is the adhesive if exposed to extremes of temperature.  It is recommended that the Patches are used within a 12-month period from the date of purchase.

Additional Information:

• Production Capacity: As per Requirement
• Delivery Time: Ex Stock

The Bresle method is used to determine concentration of soluble salts on metal surfaces prior to coating application, such as painting. These salts can cause serious adhesion problems after time.   WHAT IS SALT CONTAMINATION. Water is taken up by the fine roots of plants through the process of osmosis, which involves the movement of water from regions of low salt concentration (such as the soil) to regions of high salt concentration (such as the inside of root cells).

Additional Information:

• Production Capacity: As per Requirement
• Delivery Time: Ex Stock

The Bresle Test Kit supplies all the necessary equipment to test for chloride and soluble salt surface contaminants on blasted surfaces in compliance with ISO 8502-6 & ISO 8502-9.The test is highly important in view of Non visible salts present on the surfaces can lead to premature failures. Many coatings fail due to salts such as chlorides and sulphates contaminating the surface prior to the coating application.

This contamination can be tested quickly and simply using the Bresle Test Kit. This kit has advantage over portable units. Test can be quickly performed at site, shop floor and plants. The Bresle Patch is attached to the surface; the distilled water is injected with a syringe then extracted, repeat ten cycles of injecting and extracting then measure with the Conductivity meter.

Compact conductivity meter will measure the quantity of salts in μg/cm2 (ppm) and mg/m2. Bresle test complies with ISO 8502-6, which relates to the extraction of soluble contaminants and ISO 8502-9, which relates to the conduct metric determination of soluble salts. Calibration Certificates traceable are available for the Conductivity Meter in the kit. The Bresle Test Kit is supplied with 50 Bresle Patches, 1 Conductivity Meter, Calibration Solutions, 5x5ml Syringes, 25ml Beaker and 250ml Distilled Water. Additional Bresle Patches can be purchased to carry out further tests using this kit. Part Numbers: BTK-001 Bresle Test Kit BTK-002 Bresle Patches(Pack of 50 Nos.) BTK-003 Bottle 250ml - Distilled Water.

 

Additional Information:

• Delivery Time: Ex Stock
• Packaging Details: ABS Plastic Case